Kimiabeigi M., Widmer J. D., Long R., Gao Y., Goss J., Martin R., Lisle T., Soler Vizan J. M., Michaelides A., Mecrow B., 2016, High-performance low-cost electric motor for electric vehicles using ferrite magnets, IEEE Trans. Ind. Electron, Vol. 63, No. 1

Cao W., Mecrow B. C., Atkinson G. J., Bennett J. W., Atkinson D. J., 2012, Overview of electric motor technologies used for more electric aircraft (MEA), IEEE Trans. Ind. Electron, Vol. 59, No. 9

Park J. K., Hur J., 2016, Detection of inter-turn and dynamic eccentricity faults using stator current frequency pattern in IPM-type BLDC motors, IEEE Trans. Ind. Electron, Vol. 63, No. 3

Park J. K., Jeong C. L., Lee S. T., Hur J., 2015, Early detection technique for stator winding inter-turn fault in BLDC motor using input impedance, IEEE Trans. Ind. Appl., Vol. 51, No. 1

Singleton II R., Strangas E., Aviyente S., 2017, The use of bearing currents and vibrations in lifetime estimation of bearings, IEEE Trans. Ind. Inf., Vol. 13, No. 3

Niskanen V., Muetze A., Ahola J., 2014, Study on bearing impedance properties at several hundred kilohertz for different electric machine operating parameters, IEEE Trans. Ind. Appl., Vol. 50, No. 5

Park J. K., Wellawatta T., Choi S., Hur J., 2017, Mitigation method of the shaft voltage according to parasitic capacitance of the PMSM, IEEE Trans. Ind. Appl., Vol. 53, No. 5

Muetze A., Binder A., 2007, Calculation of circulating bearing currents in machines of inverter-based drive systems, IEEE Trans. Ind. Electron., Vol. 54, No. 2

Shami U. T., Akagi H., 2010, Identification and discussion of the origin of a shaft end-to-end voltage in an inverter-driven motor, IEEE Trans. Power Electron., Vol. 25, No. 6, pp. 1615-1625

Park J. K., Wellawatta T., Ullah Z., Hur J., 2016, New equivalent circuit of the IPM-type BLDC motor for calculation of shaft voltage by considering electric and magnetic fields, IEEE Trans. Ind. Appl., Vol. 52, No. 5

Muetze A., Binder A., 2006, Don't lose your bearings, IEEE Ind. Appl. Magazine, Vol. 12, No. 4

Muetze A., Oh H. W., 2008, Design aspects of Conductive Microfiber Rings for Shaft-Grounding Purposes, IEEE Trans. Ind. Electron., Vol. 44, No. 6

Adabi J., Boora A. A., Zare F., Nami A., Ghosh A., Blaabjerg F., 2011, Common-mode voltage reduction in a motor drive system with a power factor correction, IET Power Electronics, Vol. 5, No. 3